[Asterisk-Users] E400P

[Tais M. Hansen]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Tuesday 03 June 2003 13:53, Steve Underwood wrote:
> >Okay, I've done even more studying on these matters. It would seem QSIG is
> > not supported by E400. There're a bunch of other protocols to chose from,
> > but nothing that rings a bell.
> Q.SIG is a PBX to PBX variant to ISDN. If you can change the config of
> your switch you can probably make it do CTR4 (EuroISDN, Net5, and
> various other names), which the E400P does support. Then life will
> become much easier.

There doesn't seem to be any protocols with similar names. I'm not even sure 
the cable is connected correctly, since I can't seem to match the pinouts on 
the Siemens proprietary cable with their own documentation. This really 
stinks.


> You could, of course, contribute the changes needed to make libpri do
> Q.SIG, and everyone will benefit. :-)

I'd love to try, if I had any clue on how. I took a quick peek at the libpri 
sources and I doubt I'll figure it out anytime soon. :(


- -- 
Regards,
Tais M. Hansen
ComX
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.2 (GNU/Linux)

iD8DBQE+3J6d2TEAILET3McRAjRdAKCOVYWD9JtU6JktdbV1Jvq9sjzRSQCePuSI
Gcm+aSDDcJE/tNkEPNYIKVc=
=owpv
-----END PGP SIGNATURE-----