[Asterisk-Users] Problems with g729

[Martin Pycko]

Try the new_codec_binary/codec_g729b.so from the digium ftp site.

regards
Martin

On Wed, 23 Jul 2003, Dan Fernandez wrote:

> I am having some problems with g729 with SIP and ZAP channels.
>
> 1)
> I have two g729 licences. Very frequetnly (I don´t know what triggers the error)  I get the following warnings and error when I try to place a call via SIP to my X100P. The only way to get out of this is through a restart of *. When the error ocurrs there are no other calls in place. Any ideas?
>
>
> Error Opening channel:2 not available, see va_g729_init_global(..) WARNING[71694]:File codec_g729b.c line 102 (g729lin_new): No available g729b resource for channel 2
> WARNING:[71694] File translate.c Line 111 (ast_translator_build_path):Failed to build translator path from 8 to 6 Zap1-1 answered SIP/105-ce3c
> WARNING[71694]: File chan_zap.c Line 3367 (zt_write):Cannot handle frames in 256 format
> Hangup Zap/1-1
>
>
> 2)
>  have discovered a problem when using g729 under the following setup:
>
> SIP call between a Budgetone 102 and ATA 186  (configured without silence suppresion). Both ends have a ADSL 64kbps. Both ends are behind Linksys routers. The pings between them are aprox. 100ms. No other local users on each end.  * is being hosted on a PIII,128MB. No other calls are being handled at the time of the test.
>
>  Basically, after a few minutes, with g729, both ends consistently start getting delays up to a point where it becomes almost unbearable to speak.  If we switch to g723 the problem goes away.
>
> ANy ideas what´s going on?
>
>