[Asterisk-Users] ISDN PRI E1 configuration with E100P

[Martin Pycko]

Unfortunatelly if your telco doesn't send you any DID along with the SETUP
message you need to have immediate=yes in zapata.conf for those channels.

regards
Martin

On Fri, 11 Jul 2003 surajee at infotechs.lk wrote:

> Very sorry about the previous mail,
> heres the mail again,
>
> hi Everyone,
>
> We are configuring an ISDN PRI E1 with an E100P card, when you load the drivers, and starts the
> asterisk, cards also starts fine, givin following output,
>
> *CLI>
>   == D-Channel on span 1 up
>     -- B-channel 1 successfully restarted on span 1
>     -- B-channel 2 successfully restarted on span 1
>        . . .
>     -- B-channel 31 successfully restarted on span 1
>
> but, when we make a call to this E1 from outside, it gives the following error,
>
> WARNING[213006]: File chan_zap.c, Line 5248 (pri_fixup): Call specified, but not found?
> WARNING[213006]: File chan_zap.c, Line 5786 (pri_dchannel): Hangup on bad channel 1
> WARNING[213006]: File chan_zap.c, Line 5248 (pri_fixup): Call specified, but not found?
> WARNING[213006]: File chan_zap.c, Line 5786 (pri_dchannel): Hangup on bad channel 2
>
> does anybody hav an idea on this?
>
> our zaptel.conf is,
>
> #E100p card
> span=1,0,0,ccs,hdb3,crc4
> bchan=1-15,17-31
> dchan=16
>
> zapata.conf,
>
> ;E100p card
> switchtype=EuroISDN
> signalling=pri_cpe
> pridialplan=unknown
> context=incoming
> group = 2
> channel => 1-15,17-31
>
> Thanks inadvance,
>
> Surajee
>
>
>
> --------------This mail sent through OmniBIS.com--------------
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>