[Asterisk-Users] TDM10B - Dies after a few hours

[Derek Beaumont]

You might be experiencing a PCI Master Abort.  Type dmesg.
If you see PCI Master Abort, then that is your problem.  If
you don't, then I'm out of ideas.

-Derek

-----Original Message-----
From: asterisk-users-admin at lists.digium.com
[mailto:asterisk-users-admin at lists.digium.com] On Behalf Of Brad Bergman
Sent: Thursday, July 10, 2003 11:52 AM
To: asterisk-users at lists.digium.com
Subject: [Asterisk-Users] TDM10B - Dies after a few hours

I've been having trouble with a TDM10B that I installed a few days ago.

At first I could not modprobe it at all (getting the errors below). I
switched the X100P that was also installed (with a Motorola chip) with
one
with a Tiger-something chip, and then everything starts up okay.

However, after a few hours, the FXS port dies (no battery or anything), 
and if I try to rmmod & modprobe again, I can't.

modprobe wcfxs
/lib/modules/2.4.18-14/misc/wcfxs.o: init_module: No such device
Hint: insmod errors can be caused by incorrect module parameters, 
including invalid IO or IRQ parameters.
      You may find more information in syslog or the output from dmesg
/lib/modules/2.4.18-14/misc/wcfxs.o: insmod 
/lib/modules/2.4.18-14/misc/wcfxs.o failed
/lib/modules/2.4.18-14/misc/wcfxs.o: insmod wcfxs failed

I have seen a couple of references to this or similar problems, but no 
solution...
http://lists.digium.com/pipermail/asterisk-users/2003-May/011171.html
http://lists.digium.com/pipermail/asterisk-users/2003-May/012891.html

Anyone have any ideas?  I realize that there are some problems with the
board in general, but this one doesn't really seem similar.

Thanks,
Brad

_______________________________________________
Asterisk-Users mailing list
Asterisk-Users at lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users