[Asterisk-Users] E100P connected to Cisco

[Martin Pycko]

You need to have HDLC generic support compiled into your kernel ... I
think it's not good to have it compiled in modules ... just embedded in
kernel.

Martin

On Sat, 20 Dec 2003, Daniel Bichara wrote:

> Hi All,
>
> I wish to connect * to a Cisco using a E100P board.
>
> When I load the driver I got this error message:
>
> -bash-2.05b# modprobe wct1xxp
> ZT_CHANCONFIG failed on channel 1: Function not implemented (38)
> /lib/modules/2.4.21-SAX/misc/wct1xxp.o: post-install wct1xxp failed
> /lib/modules/2.4.21-SAX/misc/wct1xxp.o: insmod wct1xxp failed
>
>
> Follows Cisco configuration:
>
> isdn switch-type primary-qsig
> isdn voice-call-failure 0
>
>
> controller E1 2
>  framing NO-CRC4
>  clock source line primary
>  pri-group timeslots 1-31
>
> interface Serial2:15
>  no ip address
>  isdn switch-type primary-qsig
>  isdn overlap-receiving T302 2000
>  isdn incoming-voice modem
>  isdn T310 40000
>  isdn send-alerting
>  no cdp enable
>
> voice-port 2:D
>  cptone BR
>
>
> I configured my /etc/zapata.conf:
>
> span=1,0,0,ccs,hdb3
> nethdlc=1-15
>
> Any clue?
>
> Thanks in advance,
>
> Daniel
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
>