[Asterisk-Users] Carrier Access Channel Bank Setup -- No hangup

[Steven Critchfield]

On Thu, 2003-12-04 at 13:42, Jonathan Moore wrote:
> Quoting Steven Critchfield <critch at basesys.com>:
> 
> > On Thu, 2003-12-04 at 11:49, Jonathan Moore wrote:
> > > I just purchased a T100p from digium and a Carrier Access Access Bank 1
> > channel
> > > bank (12fxs/12fxo). I have the setup partially working thanks to some help
> > from
> > > IRC. However I still have the following issues I can't seem to resolve
> > > 
> > > 1. When calling into the system from the PSTN call hangup is not detected.
> > *
> > > leaves line in use until it is shutdown.
> > 
> > You need to get disconnect supervision on you phone lines. Nothing short
> > is probably going to work for you.
> > 
> 
> Formerly I was using a single line FXO card from Digium and it worked perfectly
> with kewl start signalling. Does this still mean I need to get disconnect
> supervision from the telco? Just changing from ls to ks in configs doesn't seem
> to have any affect.

Where you using the busydetection and I forget what the other one is? If
so, you can probably turn them on for these channels as well and get it
to work again.

> > > 2. When calling an analog phone connected to channel bank the phone
> > doesn't
> > > ring. If you are in call and some else calls the extension you get the
> > call
> > > waiting tones and a flash works to flip to the new line.
> > 
> > Do any of the phone lines ring? Sounds like you have one of the AB1's
> > that are known to get burnt out ring generators.
> 
> Is there a way to definitively test the ring generators on the channel bank?

Outside of verifying the switches and jumpers are right, and then seeing
if the ringers work when dialed, not that I know of.
-- 
Steven Critchfield  <critch at basesys.com>