[Asterisk-Users] Asterisk with Voicetronix OpenLine4 card

[Jorge Mendoza]

Try the following:

vpb.conf:
[interfaces]
echocancel = on
board = 1
context = default
mode = fxo
channel = 3

extensions.conf:

exten => _9.,1,Dial(vpb/1-3/${EXTEN:1})
exten => _9.,2,Congestion

Hope help you

Jorge


Ahmad Faiz wrote:

>hi there,
>
>i've been able to successfully run asterisk with the Voicetronix OpenLine4
>card, it can accept calls and function normally. The only problem I'm
>experiencing so far is getting the card to outdial to a third party.
>
>What I'm trying to achieve is basically call bridging, where the caller
>dials in to asterisk, some IVR plays and then attempts to perform a
>"transfer" to a third party, and once the outbound call is connected both
>legs are bridged.
>
>I've seen some dialplans out there that use the normal Dial application. in
>my dialplan i've used various different methods:
>
>exten => s,5,Dial(55555555)
>exten => s,5,Dial(vpb/55555555)
>exten => s,5,Dial(vpb/1-3/55555555)
>
>(the third one is assuming it means board 1 line 3)
>
>in the log file, the following error is recorded each time the outbound dial
>is attempted:
>
>"File app_dial.c, Line 499 (dial_exec): Unable to create channel of type
>'vpb'"
>
>As far as the vpb.conf file goes, my attempts include:
>
>1) Setting channels 1 and 2 as FXO, channels 3 and 4 as immediate
>2) Setting channels 1 and 2 as FXO, channels 3 and 4 as dialtone
>3) Setting channels 1-4 as FXO
>
>i may have something mixed up here, has anyone had any success with this?
>note that i'm not using the OpenSwitch card, it's the OpenLine.
>
>Thanks,
>Faiz
>  
>