[asterisk-r2] Protocol error

[Gabriel Durante]

Hello Moy,

The same problem appears after uninstalling asterisk 1.6.0.6 with manual patch and upgrading to asterisk 1.6.2.0-rc3.

 

Thanks in advanced.

Regards.

 

COMMLOGIK DO BRASIL LTDA

Gabriel Durante - Depto. Técnico

Av. Dr. Guilherme Dumont Villares, 824

Portal do Morumbi - São Paulo/SP/Brasil

Cep: 05640-001

55+11+5503-1011 r/135

 <mailto:manzini at commlogik.com.br> gabriel at commlogik.com.br

www.commlogik.com.br

 

From: Moises Silva [mailto:moises.silva at gmail.com] 
Sent: quinta-feira, 15 de outubro de 2009 12:50
To: gabriel at commlogik.com.br
Subject: Re: [asterisk-r2] Protocol error

 

I will try to use asterisk 1.6.2.0-rc3 with embedded openr2 support but no promises, the last time that I’ve compiled without a manual patch I can´t see dahdi and mfcr2 on asterisk CLI (using Digium TE122/TE121).

I can assure you there is no problems with 1.6.2.0-rc3, give it a try. As I said a few weeks ago, I dropped support for 1.6.x previous to 1.6.2, is just too time consuming support so many releases and 1.6.2.0-rc3 should work pretty well.

 

If possible via advanced parameters,  allow the forward side to send 0x0C (clear back).

No, unfortunately that is not possible at this point.

 

-- 
Moises Silva
Software Developer
Sangoma Technologies Inc. | 50 McIntosh Drive, Suite 120, Markham ON L3R 9T3 Canada
t. 1 905 474 1990 x 128 | e. moy at sangoma.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-r2/attachments/20091015/5f033582/attachment.htm