[asterisk-r2] Asterisk + Sangoma A101 + OpenR2 + Axtel Telco (Mexico City)

[Ricardo Melendez]

Hi to All, I have a previous post with problems with calls but making test I
note the following.

 

1.-I have configured Elastix 1.5 + OpenR2 + Sangoma A101 all appear to work
fine,  but


2.-When I for very first time connect E1 to Sangoma Card and make test all
fine (green alarms, idle channels and incoming/outgoing calls work)

3.-After approximately 5 minutes, Red Alarms turn ON (no calls work)

4.-At this moment I take some output from 

                -wanpipemon –i w1g1 –c Ta

                -asterisk –rx ‘mfcr2 show channels’

                -wanrouter status

 

                Please review this at  http://pastebin.com/m704d2d39

 

5.-All this data indicate to me that the telco blocks the E1, well I call to
telco provider and they say to me that the link is blocked, but with some
loop test they verify that all their transporting is fine, the problem is my
PBX.

6.-OK, well, If I reboot my PBX? I think All the process restart (green
alarms, idle channels, calls working -à 5 minutes -à red alarms, blocked
channels, no calls) BUT NO. 

7.-Once RED ALARMS TURN ON, they never gone (for that day).

8.- I think if the problem is the PBX blocking E1, with every reboot  the
process will repeat but this not happen.

 

Any suggestion?

 

Thanks in advance.

 

Ricardo

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-r2/attachments/20090611/e810efbb/attachment.htm