Good Morning Everyone,<div><br></div><div>I have taken a break from developing with Asterisk until recently. I have recently started a project using Asterisk. In a nutshell this is what is happening:</div><div><br></div><div>
<ul><li>User calls the system up and logins in.</li><li>User enters in telephone #1 and telephone #2 at the appropriate prompts.</li><li>A call file is generated and placed in the outgoing spool.</li><li>The user is then placed into the ChanSpy function for a preset group id.</li>
<li>Asterisk actives the call file and dials telephone #1 (the one to chanspy on) and then dials telephone #2.</li><li>Both outbound calls are picked up.</li></ul><div>Everything is running smooth. Upon connection of the first telephone call, ChanSpy announces that it is connected to the IAX trunk. I can then hear everything telephone #1 and telephone #2 does and say with absolutely no delay. Works like a charm. </div>
<div><br></div><div>Now, here is my problem; I can't whisper to telephone #1. Nothing is getting though. I am calling chanspy as: ChanSpy(,wg(${user_spy_serial})). 'user_spy_serial' is just the users login number, which is passed in the call file as the group id for the spy.</div>
<div><br></div><div>Now, last week when I first started the project the whisper worked, however was delayed five to ten seconds (this is all done on a local network). One call it worked just fine. Now -- no whisper at all.</div>
<div><br></div><div>The only difference I have made since the chanspy was delayed was upgrade to version 1.4.26. What am I missing here? Should I not use call files? If not, how do I canspy then dial out the two numbers without the call file? What is causing me to successfully activate ChanSpy with both the whisper and group flags and hear everything, but not whisper?</div>
<div><br></div><div>I would appreciate any pointers!</div><div><br></div><div><br></div>Thank You,</div><div><br>-- <br>-Matt D.<br><br>TrustKey: 9d6e97607a12a2aaf01c787296c2e8f3<br>
</div>