[Asterisk-Dev] TE410P init problem

[Daniel Pocock]

I've got a couple of DL140 servers (HP, dual Xeon, 3.3v).  Each has a 
TE410P and identical operating system, modules, etc.  In one of the 
servers, the TE410P works fine.  In the other, when I load the wct4xxp 
module, I get the errors below.  I've seen similar stuff in the -users 
list, without any clear answers. 

Is this a driver issue, a server issue, or a faulty card perhaps?

Output from card that won't work:

Zapata Telephony Interface Registered on major 196
ACPI: PCI interrupt 0000:01:06.0[A] -> GSI 22 (level, low) -> IRQ 22
Found TE410P at base address feaffc00, remapped to f8832c00
TE410P version ffffffff
Tried to load 00000000 into 00000003, but got ffffffff instead
Tried to load 3706c800 into 00000000, but got ffffffff instead
Tried to load 3706c000 into 00000001, but got ffffffff instead
Tried to load 07fc07fc into 00000002, but got ffffffff instead
Tried to load 0000004a into 0000000a, but got ffffffff instead
Tried to load 0000044a into 0000000a, but got ffffffff instead
FALC version: 00000000, Board ID: 0f
Reg 0: 0x00000000
Reg 1: 0x00000000
Reg 2: 0x00000000
Reg 3: 0x00000000
Reg 4: 0x00000000
Reg 5: 0x00000000
Reg 6: 0xc01a009b
Reg 7: 0x00000000
Reg 8: 0x00000000
Reg 9: 0x00ff0000
Reg 10: 0x00000000
Found a Wildcard: Wildcard TE410P-Xilinx

Output from card that does work:

Zapata Telephony Interface Registered on major 196
ACPI: PCI interrupt 0000:01:06.0[A] -> GSI 22 (level, low) -> IRQ 22
Found TE410P at base address feaffc00, remapped to f8832c00
TE410P version c01a009b
FALC version: 00000005, Board ID: 00
Reg 0: 0x37093800
Reg 1: 0x37093000
Reg 2: 0x07fc07fc
Reg 3: 0x00000000
Reg 4: 0x00000000
Reg 5: 0x00000000
Reg 6: 0xc01a009b
Reg 7: 0x00001f00
Reg 8: 0x00000000
Reg 9: 0x00ff0000
Reg 10: 0x00000000
TE410P: Launching card: 0
TE410P: Setting up global serial parameters
Found a Wildcard: Wildcard TE410P-Xilinx