[Asterisk-Dev] zaptel and distinctive ring question...

[Philip Warner]

I have a TDM400 with an fxo card installed; zaptel.conf is setup for 
distinctive ring, but it only partly works:

Our distinctive rings have the same sound in the very first ring (one long 
tone). After that, they differ. As a result, all calls produce a dring 
signature of 0,0,0.

If I setup the dialplan to immediately hangup, then zaptel hears the next 
ring and reports the different signatures correctly.

This is not ideal for three reasons: (a) the caller id seems to be part of 
the first ring, so it is lost and (b) it means a lot of rings occur before 
the phone is answered and (c) it is inelegant.

Does anyone know of parameters I can set within the zaptel driver or config 
files to cause it to wait a little longer before reporting the dring type? 
Or any other solution...


----------------------------------------------------------------
Philip Warner                    |     __---_____
Albatross Consulting Pty. Ltd.   |----/       -  \
(A.B.N. 75 008 659 498)          |          /(@)   ______---_
Tel: (+61) 0500 83 82 81         |                 _________  \
Fax: (+61) 03 5330 3172          |                 ___________ |
Http://www.rhyme.com.au          |                /           \|
                                  |    --________--
PGP key available upon request,  |  /
and from pgp.mit.edu:11371       |/