[Asterisk-bsd] Partial indirect register load failed.

[ches]

I have some time to spare to play with Asterisk and, if necessary, the FreeBSD
drivers for the Digium card I bought.  I've tried the ports and svn versions
of the drivers on my 6.2 system, and always get:

Zapata Telephony Interface Registered on major 196
Echo Canceller: MARK3
FXS device: vendor=e159 device=1 subvendor=b1d9
wcfxs0: <Wildcard TDM400P REV I> port 0xde00-0xdeff mem 0xfe9fd000-0xfe9fdfff irq 17 at device 5.0 on pci1
FXS Attach for wcfxs0: deviceID : 0xe159
wcfxs0: [FAST]
Freshmaker version: 73
Freshmaker passed register test
!!!!!!! LOOP_CLOSE_TRES  iREG 1C = 1  should be 1000
!!!!!!! RING_TRIP_TRES  iREG 1D = 8000  should be 3600
!!!!!!! COMMON_MIN_TRES  iREG 1E = 0  should be 1000
!!!!!!! COMMON_MAX_TRES  iREG 1F = 0  should be 200
!!!!!!! PWR_ALARM_Q1Q2  iREG 20 = 1480  should be 7C0
!!!!!!! PWR_ALARM_Q3Q4  iREG 21 = 37C0  should be 2600
!!!!!!! PWR_ALARM_Q5Q6  iREG 22 = 3D70  should be 1B80
!!!!!!! LOOP_CLOSURE_FILTER  iREG 23 = 3970  should be 8000
!!!!!!! RING_TRIP_FILTER  iREG 24 = 78E0  should be 320
!!!!!!! TERM_LP_POLE_Q1Q2  iREG 25 = 8B60  should be 8C
!!!!!!! TERM_LP_POLE_Q3Q4  iREG 26 = 6A40  should be 100
!!!!!!! TERM_LP_POLE_Q5Q6  iREG 27 = 8070  should be 10
!!!!!!! CM_BIAS_RINGING  iREG 28 = FFFF  should be C00
!!!!!!! DCDC_MIN_V  iREG 29 = FFFF  should be C00
!!!!!!! DCDC_XTRA  iREG 2A = FFFF  should be 1000
!!!!!!! LOOP_CLOSE_TRES_LOW  iREG 2B = FFFF  should be 1000
 !!!!! Init Indirect Registers UNSUCCESSFULLY.
Indirect Registers failed verification.

...

both FXS boards fail to initialize, but the FXOs appear to initialize properly.

...
Indirect Registers failed verification.
Module 1: FAILED FXS
Module 2: Installed -- AUTO FXO
Module 3: Installed -- AUTO FXO
Found a Wildcard TDM: Wildcard TDM400P REV I (4 modules)
Registered tone zone 0 (United States / North America)

This is the sort of thing I wouldn't bother you folks with, just find the hardware
manual and debug the driver.  But I am having trouble finding a register-level
description of the hardware.

Any suggestions concerning the problem ("Dude, you need a newer PCI bus") or
pointers to the relevant docs would be appreciated.

Bill Cheswick
ches at cheswick.com