[asterisk-biz] OT: Cisco 3810

[Jon Weisman]

No I figured it out.

You need to boot the router to the ROMMON prompt, then type "voice E1"

Thanks!

-Jon


----- Original Message ----- 
From: "Joe Antkowiak" <jantkowiak at netigent.net>
To: "Commercial and Business-Oriented Asterisk Discussion" 
<asterisk-biz at lists.digium.com>
Sent: Friday, August 08, 2008 5:40 PM
Subject: Re: [asterisk-biz] OT: Cisco 3810


> should be on the user's list...but in any case try:
>
> host(config)# card type e1 [card/slot/port/etc -- use ?]
>
>
>
> Jon Weisman wrote:
>> Anybody here know how to change the T1 port in this gateway to an E1? The
>> label on the device says T1/E1, so I'm assuming it can be done, but have 
>> had
>> zero luck finding any documentation.
>>
>> Thanks,
>> Jon
>>
>>
>>
>> _______________________________________________
>> --Bandwidth and Colocation Provided by http://www.api-digital.com--
>>
>> AstriCon 2008 - September 22 - 25 Phoenix, Arizona
>> Register Now: http://www.astricon.net
>>
>> asterisk-biz mailing list
>> To UNSUBSCRIBE or update options visit:
>>    http://lists.digium.com/mailman/listinfo/asterisk-biz
>
> _______________________________________________
> --Bandwidth and Colocation Provided by http://www.api-digital.com--
>
> AstriCon 2008 - September 22 - 25 Phoenix, Arizona
> Register Now: http://www.astricon.net
>
> asterisk-biz mailing list
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-biz