[Asterisk-video] Confiance video mixer

[Lorenzo Miniero]

Hi Takashi,

from looking again at the Asterisk dump of your previous mail, I could see 
a "Video: no format line", which means MeetMe didn't see any video codec 
associated to your call. Considering that the SIP signaling instead seems to 
be negotiating video, at least on the client side, did you enable 
the "videosupport=yes" in sip.conf?

However, try sending me the console outputs from Asterisk (the module loading 
phase, the 'xcon info' command results, and what appears during a call, 
expecially when requesting the video floor) and the Confiance Videomixer 
(only the startup, the negotiation of your new peer, and it being enabled if 
so), and I'll see if I can understand where the problem is. Send them 
privately so that we do not bother the ML :)

Regards,
Lorenzo

-- 
Lorenzo Miniero, Junior Researcher
Dipartimento di Informatica e Sistemistica
Università degli Studi di Napoli "Federico II"
Via Claudio 21 -- 80125 Napoli (Italy)
Phone: +390817683821 - Fax: +390817683816
Email: lorenzo.miniero at unina.it


On Thursday 13 September 2007 11:31:24 Takashi Ohashi wrote:
> Hi Lorenzo
>
> I appreciate  your response soon.
> It as soon as I'll step in there
>
> > 1) check that the video device in the Minisip preferences is correctly
>
> setup
>    Now I think that the video device in the Minisip preferences is
> correctly setup.
>
> > 2) check that the videomixer settings are correctly set in the xcon.conf
>
> file
>    I attach xcon.conf and extensions.conf  below.
>
> > 3) if so, do you at least see the Confiance logo when joining a
>
> conference?
>   When joining a conference, I can not see the Confiance logo.