<div dir="ltr">Hello users,<div><br></div><div>I have a Digium Te235 and asterisk 13  which have worked well with 1 carrier but we have failed to add a 2nd carrier. The second telco brings their E1 line over finer, terminated in a RAD modem and they give me ethernet to the E1 card. It's the first time i am having install such a solution, which ideally would be not a big problem.</div><div><br></div><div>However, The  physical layer has failed to come up! I have tried the same setup in an Alcatel OmniOCX and it works well. I can confirm that the port is also well configured because when I interchange the cables (with the exiting cable from the other telco), the alarm clears emmediately for the 1st telco and becomes RED for the 2nd telco. A loop also clears the alarm on both ports.</div><div><br></div><div>The telco has told me to make sure that Line Impedance is 120 ohms but There's no where to set that and when I was reading, I was told that E1 is already 120 ohms so no need to change anything.</div><div><br></div><div>Has anyone here experienced this?  What other things can I try?</div><div><br></div><div>Thank you!</div><div><br></div><div>Regards,</div><div>Tim</div></div>