Hi,<br><br>In my lab, I'm testing BRI spans in NT/ptmp mode.<br>My setup is:<br>asterisk 11.2.1<br>libpri 1.4.14<br>dahdi 2.6.1<br>wctdm24xxp (HA8 hybrid with B400M)<br><br>SIP phone <----> Asterisk with HA8 <----> Patton SN4638 <----> Asterisk <----> SIP phone<br>
<br>The single BRI line I'm testing remains down:<br>CLI> pri show spans<br>PRI span 1/0: In Alarm, Up, Active<br><br>I'm quite certain this doesn't come from cabling as this setup worked OK in TE/ptmp mode (ie Patton gateway acting as network and asterisk as terminal).<br>
<br>[ 212.102644] wctdm24xxp 0000:0a:01.0: Found a Hybrid card: HA8-0000 (4 BRI spans, 0 analog channels)<br>[ 212.226050] wctdm24xxp 0000:0a:01.0: xhfc: Configuring port 0 span 1 in NT mode with termination resistance ENABLED<br>
<br>CLI> pri show span 1<br>Primary D-channel: 3<br>Status: In Alarm, Up, Active<br>Switchtype: EuroISDN<br>Type: BRI Network PTMP<br>Remote type: Unknown node type<br>Overlap Dial: 0<br>Logical Channel Mapping: 0<br>
Timer and counter settings:<br>
N200: 3<br> N202: 3<br> K: 1<br> T200: 1000<br> T201: 1000<br> T202: 10000<br> T203: 10000<br> T303: 4000<br> T305: 30000<br> T308: 4000<br> T309: 6000<br> T312: 6000<br> T313: 4000<br> T316: -1<br> N316: 2<br>
T-HOLD: 4000<br> T-RETRIEVE: 4000<br> T-RESPONSE: 4000<br> T-STATUS: 4000<br> T-ACTIVATE: 10000<br> T-DEACTIVATE: 4000<br> T-INTERROGATE: 4000<br> T-RETENTION: 30000<br> T-CCBS1: 4000<br> T-CCBS2: 2700000<br> T-CCBS3: 20000<br>
T-CCBS4: 5000<br> T-CCBS5: 3600000<br> T-CCBS6: 3600000<br> T-CCNR2: 10800000<br> T-CCNR5: 11700000<br> T-CCNR6: 11700000<br>Q931 RX: 0<br>Q931 TX: 0<br>Q921 RX: 0<br>Q921 TX: 2<br>Q921 Outstanding: 0 (TEI=127)<br>
Total active-calls:0 global:0<br>CC records:<br>Overlap Recv: No<br><br><br>As I was suspicious this came from the fact I previously used the same box in TE/ptmp, I re-ran my installation script from the start but I'm still getting the same result : the line is in Alarm.<br>
<br>Any hint ?<br>Did I miss something ?<br><br>Regards<br>