Hi,<br><br>Using Xorcom's bristuff-0.4.0-RC4-xr7.tar.gz (ie asterisk 1.4.25) with an old Junghanns OctoBRI (ie not the 2.0 version), zttool shows every port in TE mode, though half of them are in NT. Alarm column shows OK for every port, such as :<br>
OK octoBRI PCI ISDN Card 1 Span 1 [TE] Lay<br>Globally, this system doesn't work (can't dial out through zaptel)<br><br><br>Replacing this board with a Junghanns QuadBRI PCIe card, zttool shows correct TE/NT modes but Alarm column shows OK for every port,such as :<br>
OK quadBRI PCI ISDN Card 1 Span 3 [NT] (ca<br>Globally, this system does work (can dial out through zaptel)<br><br>When I replaced the OctoBRI with the QuadBRI, I didn't change anything in Zaptel/Asterisk config (I simply turned the PC off and on) except removing unuseful lines in /etc/zaptel.conf and /etc/asterisk/zapata.conf.<br>
Here are those 2 files:<br><br># cat zapata.conf<br>[channels]<br>language=fr<br>context=remote<br>pridialplan=unknown<br>prilocaldialplan=unknown<br>internationalprefix = 00<br>nationalprefix = 0<br>usecallerid=yes<br>usecallingpres=yes<br>
callwaitingcallerid=yes<br>threewaycalling=yes<br>transfer=yes<br>;;;echocancel=yes<br>;;;echocancelwhenbridged=yes<br>;echotraining=yes<br>;echotraining=800<br>;relaxdtmf=yes<br>rxgain=0.0<br>txgain=0.0<br>callgroup=1<br>
pickupgroup=1<br>immediate=no<br>;callprogress=yes<br>;progzone=us<br><br><br>;signalling=bri_cpe_ptmp<br><br>group = 1<br>switchtype=euroisdn<br>signalling=bri_cpe<br>channel => 1-2<br>echocanceller=oslec,1-2<br><br>group = 1<br>
switchtype=euroisdn<br>signalling=bri_cpe<br>channel => 4-5<br>echocanceller=oslec,4-5<br><br>group = 1<br>switchtype=euroisdn<br>signalling=bri_net<br>channel => 7-8<br>echocanceller=oslec,7-8<br><br>group = 1<br>switchtype=euroisdn<br>
signalling=bri_net<br>channel => 10-11<br>echocanceller=oslec,10-11<br><br><br><br># cat ../zaptel.conf<br>loadzone=fr<br>defaultzone=fr<br># qozap span definitions<br># most of the values should be bogus because we are not really zaptel<br>
span=1,1,3,ccs,ami<br>span=2,2,3,ccs,ami<br>span=3,0,3,ccs,ami<br>span=4,0,3,ccs,ami<br><br>bchan=1,2<br>dchan=3<br>bchan=4,5<br>dchan=6<br>bchan=7,8<br>dchan=9<br>bchan=10,11<br>dchan=12<br><br><br>File /etc/default/zaptel simply includes MODULES="qozap".<br>
<br>Any hint ?<br>Regards<br>