Hey folks, <br><br>I'm pulling my hair out on this situation and would welcome some advice:<br><br>I'm using the AMI Manager to Originate calls onto 2 E&M wink T1 circuits via a T4XXP card from Digium.<br><br>Everything works fine for about 600(+/- 50) calls then the Manager is suddenly unable to launch calls. Using ZapBarge to listen to the channels themselves you can hear the dtmf digits being dialed, but then either there is dialtone (again), or a fast busy signal.
<br><br>I've also noticed(via ZapBarge) that before the T1 seizure that the call launched will immediately go to an automated message claiming that not enough digits have been dialed. The rest of the T1's become useless right after it.
<br><br>Once the T1's get into this state, even trying to launch a call directly through the dialplan experiences the same behavior. Its like the T1 has locked up.<br><br>The telco provider (quest) claims they aren't even seeing the digits placed on the circuit. They say they see the channel being grabbed, but no digits appearing.
<br><br>Verbose and debug show nothing out of the ordinary.<br><br>Could this be an issue with the Digium card? Both T1's experience the same behavior at the same time. I've tried some different settings such as callprogress=yes and busydetect=no but nothing has helped. Only restarting asterisk seems to allow another 600 calls to be processed.
<br><br>I'm using the latest asterisk release version 1.4.11 and zaptel <a href="http://1.4.5.1">1.4.5.1</a><br><br>Regards,<br><br>Whit<br>