Hi,<br>
I have an asterisk box with a TE410P (quad pri) which has 3 spans in
use, 1 and 3 to two different telcos, span 2 to a legacy Norstar MICS.<br>
Everything has been working fine for months, but early this morning,
the 1st span stopped accepting incoming calls, but outgoing calls on
this span still worked.<br>
Nothing in the logs indicates a change overnight, span reset, or anything else obvious, excep what I've noted below:<br>
<br>
- every hour, the b-channels were restarted without any indication of a problem<br>
- chan_sip stopped logging the 'retransmission' messages just before 6:13 b-channel restart<br>
- first failed incoming call at 7:40:50,&nbsp; 7:41:01&nbsp; has log entry &quot;span 1 got hangup request&quot;<br>
- 8:13 b-channel restart logged extra &quot; Got restart ack on channel 0/20 span 1 with owner&quot;<br>
- 8:43 first successful outbound call on span1 -- no evidence or reports of any problems with outbound calls on span1<br>
- 8:55 I started diagnosing problem<br>
- 9:03 successful inbound call on span 3 (different telco, different switch-type)<br>
<br>
Until 9:05 when I forced a restart, no inbound calls succeeded on span
1 -- all of them logged a 'hangup request' 11 seconds after the initial
call setup.<br>
<br>
After searching the list archives, the only mistake in my config I've
found is having both span 1 and 3 set as primary timing source (instead
of having one of the set as secondary).&nbsp;&nbsp;
/proc/zaptel/?&nbsp; shows that span3 is the timing source (since the
restart, don't know about before).<br>
Could this be the source of the problem?&nbsp;&nbsp; Why wasn't I affected before?<br>
<br>
BTW, I've been restarting asterisk every 3 or 4 days as a preventative
measure -- the current uptime for the process was less than 36 hours.<br>
<br>
<br>
Thanks for any light that can be shed....<br>
<br>
<br>
-Gary<br>
<br>