<!doctype html public "-//w3c//dtd html 4.0 transitional//en">
<html>
Dear All,
<p>I have installed Asterisk everything is OK until I tried to configure
meeting room, configuration was simple enough when I try I get a message
that it's not a valid meeting room, Now I don't have a Zaptel device on
my machine, so I found that you will have to use ztdummy to make
a dummy zaptel device on your machine and this is because of timing issues.
<p>My question is ztdummy can only be done when making asterisk or is ther
a way to do it after post installation?
<p>I am using by the way freebsd 5.3, built Asterisk from the ports successfully.
<pre>--
Thx
MAG</pre>
</html>