<br>
<br>
<br>
<table width=100%>
<tr valign=top>
<td>
<td><font size=1 face="sans-serif"><b>Steven Critchfield <critch@basesys.com></b></font>
<br><font size=1 face="sans-serif">Sent by: asterisk-users-admin@lists.digium.com</font>
<p><font size=1 face="sans-serif">03/03/2004 04:06 PM</font>
<br><font size=1 face="sans-serif">Please respond to asterisk-users</font>
<br>
<td><font size=1 face="Arial"> </font>
<br><font size=1 face="sans-serif"> To: asterisk-users@lists.digium.com</font>
<br><font size=1 face="sans-serif"> cc: </font>
<br><font size=1 face="sans-serif"> Subject: Re: [Asterisk-Users] wct1xxp module and the T100P</font></table>
<br>
<br>
<br><font size=2 face="Courier New">On Wed, 2004-03-03 at 17:01, cveazey@blackhillsfiber.com wrote:<br>
> I'm having trouble turning up a PRI to a T100P. I've read on the<br>
> Digium FAQ's that once the wct1xxp module is loaded correctly, the LED<br>
> on the T100P will flash red. I believe I've loaded the module<br>
> correctly because both wct1xxp and zaptel are listed when I do the<br>
> "lsmod" command. The LED on the card does not flash on and off. Does<br>
> anyone have any recommendations on what I could be doing wrong?<br>
<br>
Could be wrong or bad cable, could be incorrect configuration, could be<br>
no service on the line yet.<br>
<br>
Must provide data to get information.<br>
-- <br>
Steven Critchfield <critch@basesys.com><br>
<br>
<br>
__________________________________________________________________</font>
<br>
<br><font size=2 face="Courier New">I know the PRI is good to the RJ-45 right before it goes into the T100P; I've made calls on it with our T-Berd. So I'm sure the cable is ok and there is service on the line.</font>
<br>
<br><font size=2 face="Courier New">I haven't run Asterisk yet; shouldn't the card look "alive" once its driver module is loaded? </font>
<br>
<br><font size=2 face="Courier New">Thanks!</font>
<br><font size=2 face="Courier New">chris</font>
<br>
<br>