<br><font size=2 face="Courier New">> <br>
> On Wed, 2004-03-03 at 17:01, cveazey@blackhillsfiber.com wrote:<br>
> > I'm having trouble turning up a PRI to a T100P. I've read on the<br>
> > Digium FAQ's that once the wct1xxp module is loaded correctly, the<br>
> LED<br>
> > on the T100P will flash red. I believe I've loaded the module<br>
> > correctly because both wct1xxp and zaptel are listed when I do the<br>
> > "lsmod" command. The LED on the card does not flash on and off.<br>
> Does<br>
> > anyone have any recommendations on what I could be doing wrong?</font>
<br><font size=2 face="Courier New">> > Thanks! </font>
<br><font size=2 face="Courier New">> > chris<br>
> </font>
<br><font size=2 face="Courier New">></font>
<br><font size=2 face="Courier New">><br>
> Could be wrong or bad cable, could be incorrect configuration, could<br>
> be<br>
> no service on the line yet.<br>
> <br>
> Must provide data to get information.<br>
> -- <br>
> Steven Critchfield <critch@basesys.com><br>
> <br>
> <br>
> __________________________________________________________________<br>
> <br>
> I know the PRI is good to the RJ-45 right before it goes into the<br>
> T100P; I've made calls on it with our T-Berd. So I'm sure the cable<br>
> is ok and there is service on the line.<br>
> <br>
> I haven't run Asterisk yet; shouldn't the card look "alive" once its<br>
> driver module is loaded?</font>
<br><font size=2 face="Courier New">> Thanks!</font>
<br><font size=2 face="Courier New">> Chris <br>
<br>
Nope, What would answer the request placed on the line. <br>
<br>
BTW, please see about putting some sane configuration options in your<br>
mailer. I know Lotus is notoriously crappy when viewed by other readers,<br>
but that was really bad.<br>
<br>
-- <br>
Steven Critchfield <critch@basesys.com><br>
</font><font size=2 face="sans-serif">__________________________________________________________________________________</font>
<br>
<br><font size=2 face="sans-serif">Steven,</font>
<br>
<br><font size=2 face="sans-serif">Perhaps I should have posted my question differently to the list: </font>
<br>
<br><font size=2 face="sans-serif">After installing the CVS version of Asterisk, I type, "modprobe xct1xxp." The machine accepts the command but the LED on the T100P does not flash. How do I know that the T100P module has loaded correctly?</font>
<br>
<br><font size=2 face="sans-serif">(What sort of mailer config options do you recommend?)</font>
<br>
<br><font size=2 face="sans-serif">Thanks!</font>
<br>
<br><font size=2 face="sans-serif">chris</font>