[asterisk-users] Questions about extension.conf

[Danny Nicholas]

As I understand it, same => is a way to shorthand your list of the other
keywords. In the example you posted, you save 4 keystrokes for each line you
enter; not a lot of savings for this short example, but put it in a 1000+
line dialplan and it's quite a time-saver.

 

From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Shitian Long
Sent: Thursday, November 29, 2012 10:40 AM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: [asterisk-users] Questions about extension.conf

 

Hello 

 

I have been reading the sample extension.conf

 

;#######################

 

 

[outbound-freenum2]

; This is the handler which performs the dialing logic. It is called

; from the [outbound-freenum] context

;

exten => _X!,1,Verbose(2,Performing ISN lookup for ${EXTEN})

same => n,Set(SUFFIX=${CUT(EXTEN,*,2-)})                                ;
make sure the suffix is all digits as well

same => n,GotoIf($["${FILTER(0-9,${SUFFIX})}" !=
"${SUFFIX}"]?fn-CONGESTION,1)

                                                                        ;
filter out bad characters per the README-SERIOUSLY.best-practices.txt
document

same => n,Set(TIMEOUT(absolute)=10800)

same => n,Set(isnresult=${ENUMLOOKUP(${EXTEN},sip,,1,freenum.org)})     ;
perform our lookup with freenum.org

same => n,GotoIf($["${isnresult}" != ""]?from)

same => n,Set(DIALSTATUS=CONGESTION)

same => n,Goto(fn-CONGESTION,1)

same => n(from),Set(__SIPFROMUSER=${CALLERID(num)})

same => n,GotoIf($["${GLOBAL(FREENUMDOMAIN)}" = ""]?dial)               ;
check if we set the FREENUMDOMAIN global variable in [global]

same => n,Set(__SIPFROMDOMAIN=${GLOBAL(FREENUMDOMAIN)})                 ;
if we did set it, then we'll use it for our outbound dialing domain

same => n(dial),Dial(SIP/${isnresult},40)

same => n,Goto(fn-${DIALSTATUS},1)

 

exten => fn-BUSY,1,Busy()

 

exten => _f[n]-.,1,NoOp(ISN: ${DIALSTATUS})

same => n,Congestion()

 

;##########################

 

 

According to
"http://www.voip-info.org/wiki/view/Asterisk+config+extensions.conf"

 

"Syntax for defining a context: keywords exten, include, ignorepat and
switch." "same is not mentioned in this wiki." 

 

There is a part of dial plan from sample extension.conf above. My Question
is  how "same =>" key word works . 

 

Thanks

 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.digium.com/pipermail/asterisk-users/attachments/20121129/f3ff740a/attachment.htm>