[asterisk-users] BLF and call-limit in 1.8

[Pan B. Christensen]

----- Original Message ----- 
From: "Matthew Jordan" <mjordan at digium.com>
To: "Asterisk Users Mailing List - Non-Commercial Discussion" 
<asterisk-users at lists.digium.com>
Sent: Saturday, December 08, 2012 12:43 AM
Subject: Re: [asterisk-users] BLF and call-limit in 1.8

Thanks for your reply. I just tested creating a peer in sip.conf and that 
works as it should. In addition, the value of call-limit in sip show peer 
<peer> is correct (the same as in sip.conf, which in this case is 4).

-Pan

> When you enable call-limit globally for all peers, it sets the
> call-limit for all peers to INT_MAX.  Hence why each device can accept
> quite a few calls.
>
> The setting you're actually toggling is 'callcounter'.  When its enabled
> (boolean true), it sets call-limit to INT_MAX. If not present, then the
> call-limit value is used.  This is why every setting but '1' set the
> call-limit to 0.
>
> Since you're using Realtime, there me a number of issues at play. Do you
> have this problem with a peer defined in sip.conf?
>
> -- 
> Matthew Jordan
> Digium, Inc. | Engineering Manager
> 445 Jan Davis Drive NW - Huntsville, AL 35806 - USA
> Check us out at: http://digium.com & http://asterisk.org