[asterisk-users] dahdi_tool shows no alarms, but no line connected

[Roger Schreiter]

Hi,

I'm using Sangoma's wanpipe together with dahdi, all
software downloaded today at most recent version.
Hardware is Sangoma A104, a 4xE1 card.
Installation went well.

Anyway, wanrouter status shows a different result than
dahdi_tool or dahdi_scan.

I've just put a hardware loop on port 1. All the other
ports are open.

wanrouter status shows the expected result:
Device name | Protocol | Station | Status        |
wanpipe1    | AFT TE1  | N/A     | Connected     |
wanpipe2    | AFT TE1  | N/A     | Disconnected  |
wanpipe3    | AFT TE1  | N/A     | Disconnected  |
wanpipe4    | AFT TE1  | N/A     | Disconnected  |

However:
# dahdi_scan 2
[2]
active=yes
alarms=OK
description=wanpipe2 card 1
name=WPE1/1
manufacturer=
devicetype=
location=
basechan=1
totchans=31
irq=0
type=digital-
syncsrc=0
lbo=0 db (CSU)/0-133 feet (DSX-1)
coding_opts=HDB3
framing_opts=CCS,CRC4
coding=HDB3
framing=CCS


Why are the dahdi tools not reflecting the values
by wanrouter?

Roger.