[asterisk-users] Asterisk G729 codec...

[Kevin P. Fleming]

Danny Nicholas wrote:
> You should not have a G729 command on the CLI.  Codecs are addressed in
> sip.conf, dahdi.conf, etc.  restarting Asterisk might do the trick.  You
> only need to reboot for a driver level change.

This is incorrect. Digium's codec_g729a.so module does in fact add a
'g729 show' command to the CLI, when it has found at least one valid
license file. so that the user can see how many of their licensed
channels are in use.

If the 'g729 show' command is not available after you have loaded the
module, then you need to look closely at your Asterisk log files because
the module was not able to find any valid license files.

-- 
Kevin P. Fleming
Digium, Inc. | Director of Software Technologies
445 Jan Davis Drive NW - Huntsville, AL 35806 - USA
skype: kpfleming | jabber: kpfleming at digium.com
Check us out at www.digium.com & www.asterisk.org