[asterisk-users] How to enable inboundCLI forX-Lite/Asterisk phone.

[Phil Reynolds]

Quoting "Syed Nasruddin" <nasruddin at ncel.com.pk>:

>
> How do we adjust zaptel and asterisk for CLI??. Is there some variable
> to be set??.. kindly explain keeping in view your country settings this
> will give me some hint.thanks

Bearing in mind that these settings are for UK BT (even on other  
providers here, it is different), in /etc/asterisk/zapata.conf, I  
enabled the following:

distinctiveringaftercid=yes
usecallerid=yes
cidsignalling=v23 (bell and dtmf are also available - it all depends  
on what is used in your country and by the provider of your line)
sendcalleridafter=2 (this is a UK setting - it may not be needed where  
you are)

I also have callwaitingcallerid=yes, but not sure I have any workable  
use for it at present.

calllerid=asreceived is applied to the FXO port (channel 4 on my card,  
6 on yours it seems)

As I say, these settings are not necessarily correct for other countries -
in particular the signalling and need for sendcalleridafter may be different.

Can you connect a caller ID display unit to the line and check that  
caller ID is presented? If it isn't, you will need to get that enabled  
too.

There is one other problem I have found but it probably won't apply to other
countries, so see if this gets you anywhere.

-- 
Phil Reynolds
mail: phil-asterisk at tinsleyviaduct.com
Web: http://www.tinsleyviaduct.com/phil/
Waltham 66, Emley Moor 69, Droitwich 79, Windows 95


----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.