[asterisk-users] Mitel SX-200 + *

[Mark Best]

Eric,
Looks like my Mitel does support ESF; I'll try changing it. One question
before I do. If I change it right now, do you suppose my Telco
automatically adapt?
TELCO---T1---MITEL


-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Eric
Wieling
Sent: Tuesday, March 04, 2008 12:58 PM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [asterisk-users] Mitel SX-200 + *

I would strongly recommend ESF/B8ZS. If you have a RED alarm that means 
the device does not see a line connected to it -- check cabling.

Mark Best wrote:
> Does anyone have any experience getting a Mitel SX-200 EL/ML PBX
system
> to work with *?
> 
> I'm not getting inbound or outbound calls to work. (Inbound caller
gets
> line busy tone.)
> 
>  
> 
> SETTINGS FROM MITEL:
> 
> I built a Crossover cable and connected it like this:
> 
> PSTN--T1--ASTRISK--T1--OLD MITEL
> 
>             -Crossover Cable Pin-out:
> 
>                         1 - 4
> 
>                         2 - 5
> 
>                         4 - 1
> 
>                         5 - 2
> 
> Mitel Settings:
> 
>             Line Coding = B8ZS Framing = D4 (T1 Card 9109-021-001-NA)
> 
>             (My config: span=1,1,0,d4,b8zs & e&m=1-24)
> 
>  
> 
> The card is a 24 channel T1 - not a PRI right? (T1 E&M Emulation
Trunk:
> 1)
> 
> So does that mean I use E&M with Winkstart?
> 
>             (signalling=em_w) (is this spelt right?)
> 
>             (Wink setting is an assumption based upon a setting I saw
in
> the PBX called wink timer)
> 
>  
> 
> Using a Sangoma A104D:
> 
>             zttool
> 
>                         -GAVE "OK" on PSTN
> 
>                         -Gave "RED" on MITEL
> 
>             Timing
> 
>                         -Receiving Time from PSTN & Giving to the
Mitel
> 
>  
> 
> What debugging can I do to get more information?
> 
> 
> 
> 
>
------------------------------------------------------------------------
> 
> _______________________________________________
> -- Bandwidth and Colocation Provided by http://www.api-digital.com --
> 
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users

-- 
Consulting for Asterisk, Polycom, Sangoma, Digium, Cisco, LAN, WAN, QoS,

T-1, PRI, Frame Relay, Linux, and network design.  Based near 
Birmingham, AL.  Now accepting clients worldwide.

_______________________________________________
-- Bandwidth and Colocation Provided by http://www.api-digital.com --

asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users