[asterisk-users] Trouble with PRI config

[Eric "ManxPower" Wieling]

This will happen if the other side is configured the same as the 
Asterisk side.  i.e. PRI CPU mode on both ends or PRI NET mode on both 
ends.  This can also happen if the line is in loopback mode at the far end.

Eve-Ellen Cole wrote:
> 
> 
> The underscore helped, but didn't resolve the real issue.  Now I get the 
> following messages:
> 
> [Jun 19 13:36:15] WARNING[4288] chan_zap.c: PRI Error on span 0: We 
> think we're the CPE, but they think they're the CPE too.
> 
> [Jun 19 13:36:16] WARNING[4288] chan_zap.c: No D-channels available!  
> Using Primary channel 48 as D-channel anyway!

-- 
Consulting for Asterisk, Polycom, Sangoma, Digium, Cisco, LAN, WAN, QoS, 
T-1, PRI, Frame Relay, Linux, and network design.  Based near 
Birmingham, AL.  Now accepting clients worldwide.