[asterisk-users] switchtype and signalling query

[Simon Alman]

Hi Guys

I'm configuring a TE212P card and have the following two entries in my 
/etc/asterisk/zapata.conf

switchtype=dms100
signalling=pri_cpe

When I reload asterisk I get the following messages:
>     -- Reloading module 'chan_zap.so' (Zapata Telephony)
>   == Parsing '/etc/asterisk/zapata.conf': Found
> [Mar 30 17:48:42] WARNING[2985]: chan_zap.c:11072 process_zap: 
> Ignoring switchtype
> [Mar 30 17:48:42] WARNING[2985]: chan_zap.c:11072 process_zap: 
> Ignoring signalling
However pri show span 1 shows the right values set for both:
> ast1*CLI> pri show span 1
> Primary D-channel: 24
> Status: Provisioned, In Alarm, Down, Active
> Switchtype: Nortel DMS100
> Type: CPE
> Window Length: 0/7
> Sentrej: 0
> SolicitFbit: 0
> Retrans: 0
> Busy: 0
> Overlap Dial: 0
> T200 Timer: 1000
> T203 Timer: 10000
> T305 Timer: 30000
> T308 Timer: 4000
> T309 Timer: -1
> T313 Timer: 4000
> N200 Counter: 3
Should I be concerned as to the Warnings ? I'm not quite at the stage 
where I can test my setup yet and wanted to check before I get there.

Many thanks for your time.

Simon