[asterisk-users] TDM400p, no CLI activity

[joe a.]

Thanks.

Turns out etc/asterisk/zapata.conf had two entries for [channels].   First one was blank.  I
 had cut and pasted and somehow did not notice this utill I was on the phone with Digium.

I guess asterisk reads the first and ignores the next one.  Removing the first one fixed the problem.   

joe a.

Giorgio Incantalupo<gincantalupo at fgasoftware.com> Wrote: 3/19/2007 12:22 PM:
> Hi joe,
> seems like your card is working but not your modules...have you checked 
> if the led on the TDM400P are on?
> Try to change the FXO/FXS modules, maybe they are not working good.
> 
> 
> Giorgio
> 
> 
> joe acquisto wrote:
>> New install, using TDM400p.  wctdm is loaded, asterisk loads.   Zaptel and 
>> zapata.conf are from a working system, same model board, same module 
>> locations.
>>
>> CLI command zap show status shows all OK, zap show channels shows nothing 
>> defined.
>>
>> Incoming calls show nothing on CLI, analog handsets have no dial tone and, 
>> of course, shown nohting on CLI.
>>
>> joe a.
>>
>> _______________________________________________
>> --Bandwidth and Colocation provided by Easynews.com --
>>
>> asterisk-users mailing list
>> To UNSUBSCRIBE or update options visit:
>>    http://lists.digium.com/mailman/listinfo/asterisk-users 
>>
>>   
> 
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
> 
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users