[asterisk-users] Zaptel problem after upgrading to 1.2.16

[Mark Davies]

Never mind - I seem to have fixed this.  I had unloaded zaptel and wctdm
when recompiling everything, so asterisk apparently didn't compile those
modules because I assume it didn't think I had the hardware installed.

 

 

All working!

 

 

 

From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Drew
Gibson
Sent: Saturday, 10 March 2007 12:04 AM
To: Asterisk Users Mailing List - Non-Commercial Discussion
Subject: Re: [asterisk-users] Zaptel problem after upgrading to 1.2.16

 

Mark Davies wrote: 

Hi guys,

 

I'm hoping I've made a silly mistake here, but I've been staring at the
screen for the past few hours and I can't work it out.

 

I upgraded to 1.2.16 recently, and am having problems with zaptel.

 

The card is detected, I get a reasonable output from ztcfg -vv, and
zttool shows the installed module (TDM400) with one FXS module.

 

But when I start asterisk, I get an error saying that my IAX connection
won't work in trunked mode because there's no timing interface.  Zaptel
doesn't show up in the output of show channeltypes.

 

Should there be a problem with using the trunk version of zaptel, but
1.2.16 of asterisk?

 

Are there any places that I can specifically load/enable the zaptel
module?

Is there a chan_zap.so in /usr/lib/asterisk/modules?
Are you upgrading over an existing install of Asterisk, or did you
remove the old ver first?

I had trouble building Asterisk 1.2.15 with the 1.4 zaptel driver.
Asterisk did not find the zaptel src and wouldn't build chan_zap.so.

regards,

Drew




-- 
Drew Gibson
 
Systems Administrator
OANDA Corporation
www.oanda.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20070310/a7bef0a4/attachment.htm