[asterisk-users] vzaphfc?

[Tzafrir Cohen]

On Wed, Jan 03, 2007 at 07:16:06AM +0100, Remco Barendse wrote:
> On Wed, 3 Jan 2007, Tzafrir Cohen wrote:
> 
> >>P[ 0] -- mISDN Channel Driver Registred -- (BE AWARE THIS DRIVER IS
> >>EXPERIMENTAL!)
> >>......Jan  2 23:07:23 ERROR[25747]: chan_zap.c:10603 setup_zap: Unknown
> >>signalling method 'bri_cpe_ptmp'
> >
> >our Asterisk is not bristuffed. And you don't expect to use ZapBRI,
> >anyway.
> >
> >BTW: with 1.4 and latest 1.2, bristuffed zaptel could basicaly work with
> >the signalling  type pri_cpe/pri_net, though this is not well-tested and
> >may not perform as well as bristuffed asterisk/libpri.
> >
> >>Jan  2 23:07:23 ERROR[25747]: chan_zap.c:10228 setup_zap: Signalling must
> >>be specified before any channels are.
> >>Jan  2 23:07:23 WARNING[25747]: loader.c:414 __load_resource: chan_zap.so:
> >>load_module failed, returning -1
> >>Jan  2 23:07:23 WARNING[25747]: loader.c:554 load_modules: Loading module
> >>chan_zap.so failed!
> >
> >You have zaptel channels configured in your zapata.conf .
> So I should leave both zaptel.conf and zapata.conf completely empty?

/etc/zaptel.conf is used to configure the kernel modules. It is used by
ztcfg.

/etc/asterisk/zapata.conf is used by Asterisk's chan_zap . Asterisk will
try to use any channel listed there. If no channel is listed there,
Asterisk will not attempt to use any.

(except possibly the pseudo channel for zaptel timing, if you happen to
have any zaptel device that provides timing, or ztdummy)

-- 
               Tzafrir Cohen       
icq#16849755                    jabber:tzafrir at jabber.org
+972-50-7952406           mailto:tzafrir.cohen at xorcom.com       
http://www.xorcom.com  iax:guest at local.xorcom.com/tzafrir