[asterisk-users] PhonicEQ T100P

[Ritesh Agrawal]

Hi,

Does anyone have any experience with the PhonixEQ T100P card?
I wanted to know if it works fine with Asterisk without much of an issue.

Thanks for your comments.


TE100P 1 Port T1/E1 ISDN PRI Interface Card

datasheet <http://store.phoniceq.com/datasheet/te100p-datasheet.pdf>  TE100P
offers unprecedented density and value in the telephony arena. Terminating
one T1/E1 interface in a single PCI form-factor device, the TE100P harnesses
the benefits of standard PC hardware and the open source Linux operating
system.

TE100P supports industry-standard telephony and data protocols, including
both the CAS, CAS R2, Robbed Bit Signaling and Primary Rate ISDN protocol
families for voice, as well as PPP, Cisco HDLC, and Frame Relay data modes.
The card is fully supported by the Asterisk Open Source PBX and can drive
both line-side and trunk-side interfaces, including supporting advanced call
features. In addition to conventional telephony, Asterisk extends the
strengths of the TE100P to provide Voice over IP and ultra low-latency TDM
over Ethernet for greater efficiency and flexibility.

Important Note: TE100P is for use with both a 3.3 *and* 5.0 volt PCI slot.

Ritesh
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.digium.com/pipermail/asterisk-users/attachments/20070802/0e9db412/attachment.htm