[asterisk-users] Asterisk 1.2.16 - No Caller ID

[OCOSA ListAcct]

Eric,

Thanks when I took the rx and tx to 0.0 on both the caller id showed up 
I guess I will play with. My main reasoning for adjusting the rx and tx 
was to get rid of the echo...What other tips do you suggest or anyone 
out there? Thank you!

--------------------------------------------
Otis Surratt Jr. / listacc at ocosa.com
OCOSA Communications, LLC
PH: 918.585.9882 x 205 Fax: 918.585.5857
Visit Tulsa's Best Internet Data Center:
http://www.ocosa.com/hosting/colo/index.asp
--------------------------------------------



Eric "ManxPower" Wieling wrote:
> OCOSA ListAcc wrote:
>> Eric,
>>
>> I have watched the CLI before and it said nothing although I did 
>> change the position of the callerid = asreceived to right below and 
>> nothing it still shows up on the phones "asterisk" and in voice mail 
>> sent via e-mail unknown caller:
>>
>> Here is an output from a while back but it stopped so I do not know 
>> what is up.....
>>
>> -- Starting simple switch on 'Zap/1-1'
>> Apr  6 16:54:39 ERROR[4726]: callerid.c:276 callerid_feed: fsk_serie 
>> made mylen
>> < 0 (-92)
>> Apr  6 16:54:39 WARNING[4726]: chan_zap.c:6255 ss_thread: CallerID 
>> feed failed:
>> Success
>> Apr  6 16:54:39 WARNING[4726]: chan_zap.c:6299 ss_thread: CallerID 
>> returned with
>> error on channel 'Zap/1-1'
>
> These errors usually indicate that your rxgain for the FXO ports is 
> either too high or too low.  Change the rxgain in 
> /etc/asterisk/zapata.conf in increments of 2 either up or down until, 
> but you generally don't want it to be less than -10 or greater than 
> 10.  "reload chan_zap.so" should apply the gain changes.
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
>
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users