[asterisk-users] BeroNet HFC-4S card is now detected as only 2 ports

[Henrik Woffinden]

Hello list,

After upgrading from BRIstuff 1y-b to 1y-e my ISDN card is suddently
detected as 2 ports instead of 4.

I still load the driver as "modprobe qozap ports=12" as I've always
done. But now it only sees 2 ports.
Output of "lspci -vvv"
------ cut --------
02:01.0 ISDN controller: Cologne Chip Designs GmbH ISDN network
Controller [HFC-4S] (rev 01)
        Subsystem: Cologne Chip Designs GmbH Unknown device b560
        Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
        Interrupt: pin A routed to IRQ 22
        Region 0: I/O ports at ddb8 [size=8]
        Region 1: Memory at fcefa000 (32-bit, non-prefetchable) [size=4K]
        Capabilities: [40] Power Management version 2
                Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA
PME(D0+,D1+,D2+,D3hot+,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-
------ cut --------

Anyone has any ideas?

-- 
Best regards,

Henrik Woffinden