[asterisk-users] Optus PRI via DSL

[Paul Hales]

I have seen an Optus SHDSL box set up incorrectly before - and the tech
re-visited and set it up correctly within hours of being informed.

PaulH

On Fri, 2006-10-06 at 12:17 +1000, mattf at rapidnet.net.au wrote:
> There was a bit of traffic on this list a while ago regarding OPTUS
> multi line that comes in via a DSL box, and I am hoping some of those
> people are still hanging around, and solved their problems.
> 
> We apparently have a 14B channel service with optus.
> 
> I have been trying to configure Asterisk, with a TE110p card with no
> luck at this stage.
> 
> I have consoled onto the DSL box and have found the following:
> The box is an ADTRAN 408582526 SHDSL box
> The operation mode is NTU G.703 Unframed (Indep. Clk)
> 
> 
> Now when I plug in an Rj-45 from the DSL box to the TE110p I get
> nothing, and so I have made an E1 crossover, and I now get a combination
> of green lights. One on the back of the TE110p, and the G.703 light on
> the DSL modem comes on.
> 
> This would suggest to me that the physical link is working fine.
> 
> The following comes up at boot:
> TE110P: Setting up global serial parameters for E1 FALC V1.2
> TE110P: Successfully initialized serial bus for card
> Found a Wildcard: Digium Wildcard TE110P T1/E1
> Registered tone zone 1 (Australia)
> TE110P: Span configured for CCS/HDB3/CRC4
> 
> 
> my /etc/zaptel.conf is as follows:
> span=1,1,0,ccs,hdb3,crc4
> bchan=1-14
> dchan=16
> unused=15,17-31
> 
> loadzone = au
> defaultzone = au
> 
> 
> When I try and dial our inbound number, I just get a busy signal.
> 
> The fact that NTU G.703 is operating in Unframed mode on the DSL
> looks to be the problem to me, however I am in over my head a little
> with this stuff.
> 
> Unfortunately I do not have the management password to login and change
> the framing on the HDSL modem.
> 
> Would I be correct to say if I use clear channel on the TE110p (ie not
> use framing) it would work, and how do I set this on the card?
> 
> Anyone have any ideas of where I should go from here?
> 
> Thanks in advance
> 
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
> 
> asterisk-users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users