[asterisk-users] Asterisk and TDM400P ?

[Pranav Peshwe]

Noc Phibee wrote:
> thanks for this information, but no change:
>
> Nov 24 10:32:42 WARNING[6346] chan_zap.c: Unable to specify channel 4: 
> No such device or address
> Nov 24 10:32:42 ERROR[6346] chan_zap.c: Unable to open channel 4: No 
> such device or address
> here = 0, tmp->channel = 4, channel = 4
> Nov 24 10:32:42 ERROR[6346] chan_zap.c: Unable to register channel '4'
> Nov 24 10:32:42 WARNING[6346] loader.c: chan_zap.so: load_module 
> failed, returning -1
> Nov 24 10:32:42 WARNING[6346] loader.c: Loading module chan_zap.so 
> failed!
Hi,

Check your /etc/zaptel.conf and ensure that it has the right kind of
signalling set for the same channel number as that in you zapata.conf.

do : cat /proc/zaptel/1
and it should show channels and the effective signalling settings for them.
If signalling does not appear here,it means that, it is not configured 
properly,
and loading chan_zap would fail.

My first and fourth channels are configured as fxsks and the output i 
get is :

#cat /proc/zaptel/1
Span 1: WCTDM/0 "Wildcard TDM400P REV E/F Board 1"

           1 WCTDM/0/0 FXSKS
           2 WCTDM/0/1
           3 WCTDM/0/2
           4 WCTDM/0/3 FXSKS


HTH  :)

Regards,
Pranav

--------------------------------------------------------------------------
Blessed are the pessimists, for they take backups !!