[Asterisk-Users] Help with IRQ conflict between wct2xxp and eth0

[Giorgio Incantalupo]

Hi Phil,
may sound a stupid advice but....have you tried to change PCI slots on 
your server?

Giorgio

Phil Menico wrote:
>
> I have a conflict problem with the eth0 card and wct2xxp digium board. 
> The PRI can receive calls but my network connection is gone.
>
> When I "cat /proc/interrupts" I get the following:
>
> 1 ..
>
> 1 ..
>
> ..
>
> ..
>
> ..
>
> 169 0 IO-APIC-level wct2xxp, eth0
>
> ..
>
> etc.
>
> even before I "modprobe wct2xxp"
>
> After I "modprobe wct2xxp" and "modprobe wctdm" and again run "cat 
> /proc/interrupts"
>
> I then get:
>
>  
>
> ..
>
> ..
>
> ..
>
> ..
>
> ..
>
> 169 118489 IO-APIC-level wct2xxp, eth0
>
> 201 118497 IO-APIC-level wctdm
>
> ..
>
> etc
>
>  
>
> How can I force the wct2xxp to load on a separate IRQ? I tried moving 
> the eth0 to IRQ 10 but could not.
>
> Any ideas?
>
>  
>  
>
> Thank you.
>
> _*/Phil Menico/*_
>
> XTEND Communications
> 171 Madison Avenue, New York, NY 10016
> 212-951-7632 (Office)
> 212-951-7683 (Fax)
> www.xtend.com
>
>      
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com --
>
> Asterisk-Users mailing list
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>