[asterisk-users] Clocking Multiple T1 Cards

[Shaw Terwilliger]

[ I originally sent this to the list last week but it never arrived;
  it may have been stuck in moderation because the sending address is
  not my subscribed address.  I apologize if you get this twice. ]

I have a Digium TE205P connected to two channel banks in my Asterisk.
PBX.  I will be installing a Sangoma A101 to be connected to a PSTN PRI
in the same box.  How should I go about configuring the T1 timing for
these spans?  Right now my zapata.conf contains span definitions like
the following:

span=1,0,0,esf,b8zs
span=2,0,0,esf,b8zs

If I understand the timing comments correctly, using 0 for both spans
causes Asterisk to supply the timing for them, which I can't do with a
PSTN PRI (right?).

Should I anticipate any problems with this kind of configuration?  Will
I have to configure the Sangoma card in a special way, or reconfigure
the Digium card?

-- 
Shaw Terwilliger <sterwill at sourcegear.com>
SourceGear LLC



-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 254 bytes
Desc: OpenPGP digital signature
Url : http://lists.digium.com/pipermail/asterisk-users/attachments/20060724/7d3bbeb3/signature.pgp