[asterisk-users] Digium TE110P IRQ

[Lincoln Zuljewic Silva]

Hello all. I have a Digium TE110P board and when I do a "zap show 
status" on CLI I get:

Description                                                    Alarms    
    IRQ    bpviol    CRC4
Digium Wildcard TE110P T1/E1 Card 0        OK                0        0 
          0

IRQ = 0 ?

In lspci I have the board in IRQ 15:
0000:01:06.0 Network controller: Tiger Jet Network Inc. Tiger3XX 
Modem/ISDN interface
        Subsystem: Unknown device 79fe:0001
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- 
ParErr- Stepping- SERR+ FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- 
<TAbort- <MAbort- >SERR- <PERR-
        Latency: 64 (250ns min, 32000ns max)
  *      Interrupt: pin A routed to IRQ 15*
        Region 0: I/O ports at c800 [size=256]
        Region 1: Memory at fc5ff000 (32-bit, non-prefetchable) [size=4K]
        Capabilities: [40] Power Management version 2
                Flags: PMEClk- DSI+ D1- D2+ AuxCurrent=0mA 
PME(D0+,D1-,D2+,D3hot+,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

There is no difference when I load the module using:
modprobe wcte11xp irq=15
or
modprobe wcte11xp

This is normal ?
Thanks