[asterisk-users] quad T1 pri

[Kevin Savoy]

Should be span 1 for the for T1 and span 2 for the second T1 in your config.
They are both span 1.

-----Original Message-----
From: asterisk-users-bounces at lists.digium.com
[mailto:asterisk-users-bounces at lists.digium.com] On Behalf Of Jerry Geis
Sent: Thursday, July 13, 2006 12:47 PM
To: asterisk-users at lists.digium.com
Subject: [asterisk-users] quad T1 pri

I am connecting my Quad T1 card to the Siemens HIpath 4000 with pri.
Port 1 is working just fine. But port 2 is not working.
I think I have my configuration correct (see below).
Is there something special about configuring 2 PRI? I have done it with 
dual T1 no problem.
I am using asterisk 1.2.9.1 libpri-1.2.3 and zaptel 1.2.6.

THanks,

Jerry

------------------
zaptel.conf:

span=1,1,0,esf,b8zs
bchan=1-23
dchan=24

span=1,1,0,esf,b8zs
bchan=25-47
dchan=48

zapata.conf:
signalling=pri_cpe
switchtype=national
echocancel=yes
echocancelwhenbridged=yes
echotraining=400
callerid=asreceived
context=smvoice-incoming
group=1
channel => 1-23

signalling=pri_cpe
switchtype=national
echocancel=yes
echocancelwhenbridged=yes
echotraining=400
callerid=asreceived
context=smvoice-incoming
group=1
channel => 25-47

_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --

asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
   http://lists.digium.com/mailman/listinfo/asterisk-users