[Asterisk-Users] RxFax : Change FAX Resolution

[Steve Underwood]

Dushyanth Harinath wrote:

>Hey,
>
>[..snip..]
>  
>
>>>[Jan  4 18:28:20] DEBUG[8206]:
>>>==============================================================================
>>>
>>>[Jan  4 18:28:20] DEBUG[8206]: Fax successfully received.
>>>[Jan  4 18:28:20] DEBUG[8206]: Remote station id:
>>>[Jan  4 18:28:20] DEBUG[8206]: Local station id:
>>>[Jan  4 18:28:20] DEBUG[8206]: Pages transferred: 1
>>>[Jan  4 18:28:20] DEBUG[8206]: Image resolution:  7700 x 3850
>>>[Jan  4 18:28:20] DEBUG[8206]: Transfer Rate:     9600
>>>[Jan  4 18:28:20] DEBUG[8206]:
>>>==============================================================================
>>>
>>>
>>>I tried changing the image resolution by doing below in my dial plan but
>>>still i get the same resolution as above.
>>>
>>>      
>>>
>>FAX resolutions are set by the sender, not the receiver. The receiver
>>can reject modes and resolutions it does not support - super fine, grey
>>scale, colour etc - but it can't force the sender to use a higher
>>resolution.
>>    
>>
>
>Ok, Understood.
>
>What iam seeing here in the .tif image of a clean document received by
>RxFAX is lines overlapping and lines less spaced out sometimes. Iam not
>sure if its the sending FAX machine or RxFAX doing it.
>  
>
I would need to see an example to have any clue what is going on.

>Is there a way to change the image resolution mentioned in this debug
>output ?
>  
>
Why would changing this make any sense? It is the correct resolution.

>>>[Jan  4 18:28:20] DEBUG[8206]: Image resolution:  7700 x 3850
>>>      
>>>
>
>Is this the FAX resolution or the generated .tif images resolution ?
>  
>
Both. They are the same. The TIFF file is generated with the resolution 
of the received FAX.

Regards,
Steve