[Asterisk-Users] Channel bank woes - no outbound calls

[James Texter]

I'm hooked up to a regular analog POTS line.  I've tried both loop start 
and ground start, but no luck either way.  Any other thoughts?

Thanks,

James

Doug Lytle wrote:

> james.texter at cox.net wrote:
>
>> So, I'm still having this problem with outbound calls not working 
>> when using a channel bank.  I've purchased a Rhino FXO channel bank 
>> from VoIPSupply.com to make sure it wasn't an equipment problem.  I 
>> am using a Digium TE411P card, and have simplified it down to just 1 
>> port plugged into the channel bank, with just 1 analog line plugged 
>> in.  If I place an inbound call on the line, it goes through just 
>> fine.  However, if I attempt an outbound call, I get "Your call did 
>> not go through.  Please try your call again."  After much 
>> experimenting, I found out this happens if you
>>   
>
>
> James,
>
> When I have problems with outbound on my Adit 600, it's usually 
> because I have signaling screwed up on that channel.  (i.e. trying to 
> grab a groundstart line with loopstart signaling).
>
> Doug
>