[Asterisk-Users] RE: Euro-ISDN

[Francesco Peeters (Asterisk)]

On Wed, February 1, 2006 22:12, Armin Schindler said:
> On Wed, 1 Feb 2006, Aldo Bergamini wrote:
>> asterisk-users-request at lists.digium.com is believed to have said:
>>
>> >chan_capi does not set the NT-mode. Your cards driver need to do that.
>> >E.g. for Eicon DIVA Server cards, you just set the '-x' option with
>> divactrl
>> >or set NT-mode in the config wizard.
>> >chan_capi does not (need) to know anything about what protocol the card
>> is
>> >doing. CAPI is independent here.
>>
>> Ok.
>>
>> >Anyway, if the card is set to NT mode, you should specify ntmode=yes
>> >in the capi.conf to tell chan_capi to handle the progress better
>> >(get progress tones).
>>
>> Fine!
>>
>> One last related subpoint: while Eicon Diva cards have their own setup
>> application, is there anything standard to control the basic setup of
>> generic HFC-S cards? (something similar to the ztconfig tool for analog
>> cards)
>
> Sorry, I cannot answer that one. I don't know enough about these cards and
> their drivers.
>
With BRIstuff you get to use ztcfg, etc.

Cannot say anything about mISDN, CAPI...

-- 
F Peeters
  PIII 450 - 1 GB - * 1.2 - BRIstuff 0.3.0 Pre 1 - Florz patch
  2 Sweex HFC-PCI modes=2 sync_slave=2 timer_card=0
    Cologne HFC-S pins #52, #54, #55 connected in parallel for synching.
  AMD Duron 1GHz - 1GB - * 1.2.1
  2 Sweex HFC-PCI cards