[Asterisk-Users] Re: ISDN PBX integration

Shahar Livne livnes at gmail.com
Wed Sep 7 07:08:43 MST 2005


Well, I just answer myself here:

Since the ISDN PBX is just the same as ISDN phone as far as the
asterisk is concerned, NT mode on the ISDN card should be used as
well.

The difference is that the phone uses p2mp (point to multi point)
protocol, as the PBX uses p2p (point to point) protocol.
Using the bri_net signalling instead of bri_net_ptmp solves the problem.

Shahar

On 9/7/05, Shahar Livne <livnes at gmail.com> wrote:
> Hello list,
> 
> I am trying to connect an old ISDN PBX to my asterisk system.
> The setup includes an asterisk (1.0.9) running on the Soekris
> hardware, with an ISDN card (Billion BIPAC PCI), and I run
> zaphfc-bristuff-0.2.0-RC8k kernel module in NT mode (modes=1).
> 
> When I connect an ISDN phone to the card (using cross ISDN cable + 40v
> power supply), I manage to make calls from and to the asterisk.
> 
> When I try to connect the ISDN PBX instead, still using the same cross
> ISDN cable and the power supply, I get rings to the right extensions
> of the ISDN PBX, but no call setup happens, and after 2 rings comes
> silence.
> 
> I have tried this with NT and TE modes of the zaphfc kernel module (I
> thought it has to do with point-to-point or point-to-multipoint
> issue). I have tried it both with cross ISDN cable and normal ISDN
> cable (I just used Ethernet cable), all without any success (not even
> the mentioned rings).
> 
> When this ISDN PBX is connected to normal ISDN line, it just works.
> 
> If there is anyone with some knowledge about ISDN equipment and its
> integration with asterisk – I will be happy to get some advice – what
> to check or how is it actually supposed to work.
> 
> Thanks,
> Shahar
> 
> --
> Shahar Livne
> LivneX - Open Source Development and Services
> http://LivneX.com
> 


-- 
Shahar Livne
LivneX - Open Source Development and Services
http://LivneX.com


More information about the asterisk-users mailing list