[Asterisk-Users] TE110p and E1

[Stephen]

Hi All,

I managed to get it up and running. It is my telco problem. Thanks.

Regards,
Stephen

El Flynn wrote:

> Stephen wrote:
>
>> Hi All,
>>
>> I have configure my Asterisk as follow (using Asterisk at home):
>>
>> [zaptel.conf]
>> span=1,1,0,ccs,hdb3,yellow
>> bchan=1-15,17-31
>> dchan=16
>> loadzone = uk
>> defaultzone=uk
>
>
> try this in your zaptel.conf:
>
> span=1,0,0,ccs,hdb3,crc4
> bchan=1-15
> dchan=16
> bchan=17-31
>
> CRC required for E1 from telekom IIRC
>
> <snip>
>
>>
>> I am connecting my TE110P with a Balun converter where the two BNC 
>> connectors are from connected to a Fibre optic line.
>>
>> When I reboot my pc , I got my TE110P LED flashing RED slowly. But 
>> nothing happen when I hooked up to Balun Convertor. Balun convertor 
>> is 75ohm on BNC and 120ohm on RJ45.
>>
>> I am using straight through cable to connect my TE110P to Balun.
>>
>
> Are you sure you have the zap modules loaded?
>
> Got the same type of setup going and it works fine, as far as the 
> physical connection from E1 -> balun -> card. Try connecting it first 
> and then loading the zap modules, although it shouldn't make any 
> difference.
>
> In any case, start up asterisk with -vvvvvdgc and see what kind of 
> errors are showing up.
>
> Flynn
>
> _______________________________________________
> --Bandwidth and Colocation sponsored by Easynews.com --
>
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users
>
>
>