[Asterisk-Users] asterisk@home isdn

[Asterisk at Home]

Asterisk at Home 2.1 has a script that installs bristuff
for you. it's called install-bristuff

2.1 should be release soon.



--- Alejandro Vargas <alejandro.anv at gmail.com> wrote:

> I'm testing asteriskathome with an ISDN card
> 
> 00:0a.0 Network controller: Cologne Chip Designs
> GmbH ISDN network
> controller [HFC-PCI] (rev 02)
> 
> I found there is the module hisax and I loaded it:
> 
> hisax                 456177  0
> crc_ccitt               2113  2 hisax,zaptel
> isdn                  133409  1 hisax
> 
> dmesg shows this:
> HiSax: Linux Driver for passive ISDN cards
> HiSax: Version 3.5 (module)
> HiSax: Layer1 Revision 2.46.2.5
> HiSax: Layer2 Revision 2.30.2.4
> HiSax: TeiMgr Revision 2.20.2.3
> HiSax: Layer3 Revision 2.22.2.3
> HiSax: LinkLayer Revision 2.59.2.4
> 
> I'm not sure if it is detecting the hardware, and
> I'm not sure what
> config I must do in asterisk. The documentation is
> confusing, because
> the references to hisax indicates to use
> cahan_modem_i4l but comments
> in modules.conf says "DON'T load the chan_modem.so,
> as they are
> obsolete in * 1.2". I tryed anyway but chan_mdem_i4l
> does not appear
> whan I type reload.
> 
> --
> Alejandro Vargas
> _______________________________________________
> --Bandwidth and Colocation provided by Easynews.com
> --
> 
> Asterisk-Users mailing list
> To UNSUBSCRIBE or update options visit:
>   
>
http://lists.digium.com/mailman/listinfo/asterisk-users
> 



		
__________________________________________
Yahoo! DSL – Something to write home about.
Just $16.99/mo. or less.
dsl.yahoo.com