[Asterisk-Users] TDM400 FXO vs FXS Interrupt performance

[pdhales at optusnet.com.au]

I was pretty unhappy to see that the new cards had RJ12 sockets - you can
put RJ12 into RJ45, but not the other way round...

But I do know that a lot of people would ask if RJ12 would fit, so it might
have been to cut down on support calls.

PaulH

----- Original Message ----- 
From: "Kevin Hanson" <tuxpert at comcast.net>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"
<asterisk-users at lists.digium.com>
Sent: Monday, November 07, 2005 1:57 AM
Subject: Re: [Asterisk-Users] TDM400 FXO vs FXS Interrupt performance


> Rich Adamson wrote:
>
> >>>"Brand new " cards, from a recommended Digium distributor.
> >>>
> >>>
> >>What rev?  It'll say "Freshmaker Rev x" on the blue board.  I *think* it
was
> >>corrected around Rev E or F IIRC, but I don't know for certain.
> >>
> >>
> >>
> >>>I spoke with Digium and the distributor tech support on it - gave them
> >>>serial numbers, board rev numbers, etc. No one mentioned this.
> >>>
> >>>
> >>Probably because your boards are Rev I or later, which I believe are the
> >>current boards.
> >>
> >>
> >
> >FWIW, Rev J is current as of Oct 2005, but it is functionaly equivalent
> >to Rev I. Difference involves some line filtering required by certain
> >country stanadards and use of rj11's instead of rj45 jacks.
> >
> >
> >
> >
> >
> That's wierd.  I have two rev I TDM400's and both have rj11 jacks.  As a
> matter of fact, that caused me a bit of a problem.  I was used to rj45.
> I made up a bunch of patch cables for an install an used cat5 w/rj45.
> Tried to plug them in and guess what ...  did't fit :)
>
> Cheers,
> Kevin
>
> _______________________________________________
> --Bandwidth and Colocation sponsored by Easynews.com --
>
> Asterisk-Users mailing list
> Asterisk-Users at lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>